High tack computer stencil formulated to adhere to raw wood and urethane foam board.
Designed for use with computerized cutting machines.
Designed for machine cutting and less wear on cutting dies. Excellent blast resistance and easy-to-recognize blue liner.
This 18-mil hand cut stencil is designed for glass etching and can also be used on light stone, tile and acrylic etching.
For use on friction fed cutters. Can be used safely on pretreated or pre painted wood, urethane foam board, glass, tile, and acrylic.
Features the same construction as #123 computer stencil, with blue liner and sheet of 2-mil polyester between outside adhesive and rubber.
Same construction as our #153 stencil, except this product has a water-based acrylic adhesive, rather than petroleum based. Adhesion is much higher than # 153.
Same construction as the medium tack #117 computer stencil, except that hole pattern is for use on standard ½” center sprocket system machines.
Product has a yellow 2-mil poly film between adhesive and rubber .
42 mil, polyester adhesive. Gray rubber, translucent high liner release. Used for slot fed plotters (Gerber Format)
42 mil, polyester adhesive. Gray rubber, translucent high liner release. Used for standard ½” center tractor feed (IBM Format)
48 mil, tan, with rubber adhesive. Yellow, translucent polyester inner liner. White, polypropylene outer liner.
37 mil, green, polyester rubber adhesive with extra thick, translucent, high liner release. Highest adhesion for single liner products. Used for small design detail. Conformable for use on irregular surfaces.
50 mil, tan, with rubber adhesive. Yellow, translucent polyester inner liner. Extra thick, translucent polyester outer liner. Highest adhesion level for double lined products.